The Four Simple Steps
Step One
Adjust the electrolyte level so that it covers the electrode plates, (if necessary remove some electrolyte or top up with distilled water) - discharge the battery to approximately 50% of its capacity.
Step Two
Fill each cell using PowerBatt as inject 60 ml of PowerBatt per 100 Ah per battery cell.
For example, a 350 Ah battery will require, one dose of [350 / 100 x 60] = 210 ml per cell (fill in 3 stages 3x70 ml leaving 15 minutes between stages).
Step Three
Leave for circa 30-40 minutes to allow the chemical process to slow and the battery to cool down.
Step Four *
Charge the battery with a current of 8-10% of the battery's capacity untill the battery starts to gas or use vehicle normally.
*The battery temperature must not exceed 45 degrees Celsius (113 degrees Fahrenheit) when charged.
Please use the vehicle after adding serum. The procedure above will improve over 3 to 4 weeks/cycles of battery charge and discharge.
