The Seven Simple Steps
Step One
Adjust the electrolyte level so that it covers the electrode plates, (if necessary remove some electrolyte or top up with distilled water) - discharge the battery to approximately 50% of its capacity.
Step Two
Fill each cell inject 60ml of PowerBatt Plus per 100 Ah per battery cell.
For example, a 350 Ah battery will require, one dose of [350 / 100 x 60] = 210 ml per cell (fill in 3 stages 3x70 ml leaving 15 minutes between stages).
Step Three
Leave for circa 30-40 minutes to allow the chemical process to slow and the battery to cool down.
Step Four *
Charge the battery with a current of 8 - 10% of the battery's capacity untill the battery starts to gas.
For example, a battery with a capacity of 350Ah will be charged at a current of 35A.
Step Five
Rest the battery for circa 30-40 minutes.
Step Six *
Charge with a current of approximately 1.5 - 2% of the battery's capacity for between 70 & 80 hours.
For example, a battery with a cappacity of 350 Ah will be charged at a current of 7A. During this time discharge the battery 3 - 5 times for 2 - 5 minutes at a rate of 10 - 30% of its capacity.
Step Seven *
Discharge the battery to approximately 50% of its capacity and then charge with your standard charger (or charger suplied with the batteries)
*The battery temperature must not exceed 45 degrees Celsius (113 degrees Fahrenheit) when charged.
